Filter
Top Products
27 - 165 IP Telephony v1.0 Lab 2.1.3 Copyright © 2005, Cisco Systems, Inc.
The port on the left labeled 10/100BaseTX to Device is used to connect to the IP phone (via a
straight-through cable).The port on the right labeled 10/100BaseTX to Network is used to
connect to a non-inline power switch such as a 2950 switch (via a straight-through cable).
c. Connect a straight-through cable from the left power injector port labeled 10/100BaseTX To
Device to the IP phone port labeled 10/100 SW.
d. Connect a second straight-through cable from the right power injector port labeled
10/100BaseTX To Network to any non-inline power switch port.
e. At the opposite end of the power injector module there is a cable that goes to the power supply
adapter. The opposite end of the power supply adapter requires an AC power cord.
Plug an AC power cord into the AC adapter. Plug the other end of the AC power cord into an AC
wall outlet.
f. What indication is shown on the phone that power has been applied?
______________________________________________________________________________
_______________________