Filter
Top Products
44 - 165 IP Telephony v1.0 Lab 3.1.2 Copyright © 2005, Cisco Systems, Inc.
r. Add an ephone-dn for the first line appearance on the first phone in the pod by entering the
ephone-dn 1 dual-line command. The dual-line parameter defines the type of ephone-dn is
being created.
CMERouterX(config)# ephone-dn 1 dual-line
In ephone-dn mode enter the number X000 command (where X is the pod number).
CMERouterX(config-ephone-dn)# number X000
s. Enter a name that will be associated with this DN by entering the name firstname lastname
command. Either make up a name or use a student’s name. Example name Ray Hampton.
CMERouterX(config-ephone-dn)# name firstname lastname
Exit e-phone-dn configuration mode by typing exit.
t. From global configuration mode, enter the command ephone 1 to enter ephone configuration
mode for the first phone in the pod.
CMERouterX(config)# ephone 1
u. The MAC address of the IP phone will be needed in the next step. The MAC address is on a
sticker on the bottom of the phone. The sticker is normally located in the center. Upon close
inspection, the letters MAC are stenciled directly to the left of the white sticker that contains the
MAC address. In the space provided, write down the MAC of the first IP phone.
_________________________________________________________________
v. Assign the MAC address to ephone 1 with the mac-address H.H.H (where H is the four
hexadecimal characters). Note that the periods must be inserted between each set of four
characters, and the letters are not case-sensitive. An example entry is mac-address
0013.c43b.4999.
CMERouterX(config-ephone)# mac-address H.H.H