Filter
Top Products
26 - 165 IP Telephony v1.0 Lab 2.1.3 Copyright © 2005, Cisco Systems, Inc.
d. Connect a straight-through Ethernet cable from the 10/100 SW port on the IP phone to any 100
MB port on the inline power switch.
e. What indication is shown that the phone is receiving power? _________________________
__________________________________________________________________________
Step 3 Cabling the IP phone to a non-inline power switch
a. Connect power to the non-inline power switch.
b. In order to connect a Cisco IP phone to a non-inline power switch, a power injector is needed.
Look at the power injector and notice the two RJ-45 jacks on one end of the power injector.