Filter
Top Products
13 - 165 IP Telephony v1.0 Lab 2.1.1b Copyright © 2005, Cisco Systems, Inc.
Step 5 Assign a name to the switch
a. Enter privilege mode and then configuration mode. Use the hostname CMESwitchX command
(where X is the pod number) to name the switch. Throughout the rest of the lab, use IP
Telephony Table 1 parameters based on the pod number assigned.
Switch# configure terminal
Switch(config)# hostname CMESwitchX
Step 6 Examine the current running configuration
a. From privileged mode, exam the current configuration that follows to verify that there is no
configuration except for the hostname:
CMESwitchX# show running-config
b. Are there any passwords set on the console or VTY lines? ______________________________
c. What does the configuration show as the hostname of this switch? _______________________
Step 7 Set access passwords
Enter line configuration mode for the console port. Set the password on the console port to cisco.
Configure the VTY lines with the password of cisco.
CMESwitchX# configure terminal
CMESwitchX(config)# line console 0
CMESwitchX(config-line)# password cisco
CMESwitchX(config-line)# login
CMESwitchX(config-line)# line vty 0 15
CMESwitchX(config-line)# password cisco
CMESwitchX(config-line)# login
Step 8 Set the command mode password
a. Set the enable secret password to cisco.
CMESwitchX(config)# enable secret cisco
b. Which password takes precedence, the enable password or enable secret password?
_____________________________________________________________________________
Step 9 Configure Layer 3 access to the switch
a. Set the IP address of the switch to 10.X.0.4/24 (where X is the pod number). Note: This is done
on the internal virtual interface VLAN 1.
CMESwitchX(config)# interface vlan 1
CMESwitchX(config-if)# ip address 10.X.0.4 255.255.255.0
CMESwitchX(config-if)# description Management VLAN
b. What is the purpose of the management VLAN? _____________________________
_____________________________________________________________________________