Filter
Top Products
5-25
Cisco IP Phone Administration Guide for Cisco CallManager 3.2, Cisco IP Phones 7960/7940/7910
78-10453-04
Chapter 5 Configuring Network Settings on the Cisco IP Phone
Configuring Ports
Step 6 Use the buttons on the dial pad to enter a backup TFTP server address, using the
* key on the dial pad or the . soft key to enter periods.
Step 7 Use the << soft key to correct any mistakes.
Step 8 Press Validate.
Step 9 Press Save.
Cisco IP Phone 7910
Procedure
Step 1 Press settings.
Step 2 Press 6 (Network Configuration).
Step 3 Use the down volume key to select TFTP Server 2 setting.
Step 4 Press * to edit.
Step 5 Use the buttons on the dial pad to enter the backup TFTP server address, using the
down arrow to back space and the * key on the dial pad to enter periods.
Step 6 Press # to save.
Configuring Ports
The PC and switch (SW) port configuration settings determine the speed and
duplex of the PC and network ports, respectively.
If you change the port configuration setting value for either the PC port or the SW
port, you must change the other to match or configure both to auto-negotiate.
If the phone is connected to a switch, you must configure the switch's port to the
same speed/duplex as the phone, or configure both to auto-negotiate.
The values for both are: A (auto-negotiate), 10H (10BaseT/Half Duplex), 10F
(10BaseT/Full Duplex), 100H (100BaseT/Half Duplex), or 100F (100BaseT/Full
Duplex). This setting is not case sensitive.