Filter
Top Products
4-7
Cisco IP Phone Administration Guide for Cisco CallManager 3.2, Cisco IP Phones 7960/7940/7910
78-10453-04
Chapter 4 Adding the Cisco IP Phone 7914 Expansion Module
Installing the 7914 Expansion Module
Figure 4-3 Connector Pins on the Support Bar
Connecting the 7914 Expansion Module to the Support Bar
To connect the Expansion Module to the support bar, follow these steps.
Procedure
Step 1 Position the phone so that the front of the phone is facing up.
Step 2 Line up the two open slots on the bottom of the 7914 Expansion Module with the
two hooks on the support bar. Insert the hooks into the slots and then rotate the
top of the 7914 Expansion Module into the support bar so that it rests flush with
the bar.
Step 3 Tighten the thumb screw on the back of the 7914 Expansion Module.
Note If you are installing two Expansion Modules, repeat Steps 2 and 3 for the second
Expansion Module.