Filter
Top Products
Issue 2 January 1996 B-13
Design Configuration
Customer-Provided Multiplexor Data Networks
PROXY AGENT SOFTWARE PECs
1336-PA1 Proxy Agent (1.1) Software for customer provided PC
[CTR15-USA, CTR21-International]
1336-3F2 Fault Management Software, HP OpenView for HP-UX
1336-3F3 Fault Management Software, HP OpenView for Sun OS
1336-3F5 Fault Management Software, Cabletron Spectrum 3.1 on SunSparc/Sun OS
13360 RTU per DEFINITY G3 PBX
MINIMUM PROCESSOR HARDWARE REQUIREMENTS
• 486DX266 Processor (Intel 486 or later, 66Mhz [DX2-66] or greater Clock Speed ),
UnixWare 2.01 certified
• At least 16 MB RAM
• 256K Cache Add On
• 3.5 inch (1.44MB) floppy disk drive
• 101-key keyboard
• At least 3 ISA BUS expansion slots
•
At least a 500MB Hard Disk Drive (300 Mbytes used for Operating System and Proxy Agent)
•
1 parallel interface (female 25-pin)
•
2 serial interface (Note: Landmark Kickstart Remote Maintenance Board uses one serial interface)
•
CD-ROM Drive 2X or greater, with SCSI interface and card
•
VGA Color Monitor
•
UnixWare 2.01 compatible Ethernet LAN card (10 Mbit NIC), i.e. Intel EtherExpress 16
•
Serial I/O Port Boards (see below)