Filter
Top Products
6-12 Issue 2 April 1996
Connectivity
To Program PBX Ports
Procedure 1:
System ports
To program the system port on the switch, use the add
data-module command.
For system port cabling, typically port 1 of the data board is
cabled to port 1 of the pdata board.
Procedure 2:
Analog line
with modem
Use the following steps to program an analog line with a modem.
You must use modem pooling.
Step Action
1 Enter the following command:
add data-module
2 Enter the following:
Field For a G3r PBX … For a G3i PBX …
Ty p e system-port netcon
Port The data port
location
The data port
location
Associated
PDATA
Port
The port location of
the associated
pdata board
The port location
of the associated
pdata board
3 Use the add hunt-group command to add the system
port extension as a member of a hunt group.
End