Filter
Top Products
5-30 Issue 2 April 1996
Planning Connectivity
To Set the Dip Switch
To Set the Dip Switch
Introduction You must verify that the dip switch is set correctly. If it is not, you
need to change the settings.
When to use Set the dip switch after you have edited the Dialers file.
Settings for
the 7400B
data module
The following table explains the settings for a 7400B data module.
If the data
module is a … Then do this…
Stand alone, data-only
7400B data module
■ Turn dip switch SW1 on.
■ Leave all other dip swltches off.
Voice-and-data
7400B data module
Leave all dip switches off.