Filter
Top Products
Issue 2 April 1996 7-3
Serial I/O Cards
DigiBoard Xem
DigiBoard Xem
When to use Use this section to install and administer the DigiBoard Xem
device driver.
Materials
needed
■ Root permission
■ The DigiWare installation diskette
■ The installation guide for the DigiBoard Xem System
Installation
guidelines
Before your begin the installation:
■ Make sure your hardware is installed and all connections
are secure. (Use a DB-25 male cable.)
■ Set the DIP switch according to your hardware
configuration.
■ Write down the I/O port address. You’ll need it during the
installation procedure.
Procedural
overview
Complete the following procedures in the sequence shown.
■ Procedure 1: Install the device driver
■ Procedure 2: Configure the device driver
■ Procedure 3: Test the installation
Hint: If you need help navigating through the installation software,
refer to your DigiBoard installation guide.