Filter
Top Products
Chapter 30 Remote Management
VMG5313-B10A/-B30A Series User’s Guide
316
The following table describes the fields in this screen.
30.3 The Trust Domain Screen
Use this screen to view a list of public IP addresses which are allowed to access the VMG through
the services configured in the Maintenance > Remote MGMT screen. Click Maintenance >
Remote MGMT > Turst Domain to open the following screen.
Note: If this list is empty, all public IP addresses can access the VMG from the WAN
through the specified services.
Figure 162 Maintenance > Remote MGMT > Trust Domain
Table 134 Maintenance > Remote MGMT
LABEL DESCRIPTION
WAN Interface
used for
services
Select Any WAN to have the VMG automatically activate the remote management service
when any WAN connection is up.
Select Multi WAN and then select one or more WAN connections to have the VMG activate
the remote management service when the selected WAN connections are up.
HTTP This is the service you may use to access the VMG.
LAN/WLAN Select the Enable check box for the corresponding services that you want to allow access to
the VMG from the LAN/WLAN.
WAN Select the Enable check box for the corresponding services that you want to allow access to
the VMG from all WAN connections.
Trust Domain If you only want certain WAN connections to have access to to the VMG using the
corresponding services, then clear WAN, select Trust Domain and configure the allowed IP
address(es) in the Trust Domain screen.
Port You may change the server port number for a service if needed, however you must use the
same port number in order to use that service for remote management.
Certificate
HTTPS
Certificate
Select a certificate the HTTPS server (the VMG) uses to authenticate itself to the HTTPS
client. You must have certificates already configured in the Certificates screen.
Apply Click Apply to save your changes back to the VMG.
Cancel Click Cancel to restore your previously saved settings.