Filter
Top Products
Chapter 1 Introducing the VMG
VMG5313-B10A/-B30A Series User’s Guide
21
1.7 The RESET Button
If you forget your password or cannot access the Web Configurator, you will need to use the RESET
button at the back of the device to reload the factory-default configuration file. This means that you
will lose all configurations that you had previously and the default login names and passwords will
be reset (see the cover page).
1 Make sure the PWR/SYS LED is on (not blinking).
2 To set the device back to the factory default settings, press the RESET button for five seconds or
until the PWR/SYS LED begins to blink and then release it. When the PWR/SYS LED begins to
blink, the defaults have been restored and the device restarts.
INTERNET Green On The VMG has an IP connection but no traffic.
Your device has a WAN IP address (either static or assigned by a DHCP
server), PPP negotiation was successfully completed (if used) and the
DSL connection is up.
Blinking The VMG is sending or receiving IP traffic.
Off There is no Internet connection or the gateway is in bridged mode.
Red On The VMG attempted to make an IP connection but failed. Possible
causes are no response from a DHCP server, no PPPoE response, PPPoE
authentication failed.
LAN Green On The VMG has a successful 100 Mbps Ethernet connection with a device
on the Local Area Network (LAN).
Blinking The VMG is sending or receiving data to/from the LAN at 100 Mbps.
Off The VMG does not have an Ethernet connection with the LAN.
WiFi 2.4G Green On The 2.4 GHz wireless network is activated.
Blinking The VMG is communicating with other wireless clients.
Orange Blinking The VMG is setting up a WPS connection.
Off The 2.4 GHz wireless network is not activated.
Phone1,
Phone2
Green On A SIP account is registered for the phone port.
Blinking A telephone connected to the phone port has its receiver off of the hook
or there is an incoming call.
Off The phone port does not have a SIP account registered.
USB Green On The VMG recognizes a USB connection through the USB1 slot.
Blinking The VMG is sending/receiving data to /from the USB device connected
to it.
Off The VMG does not detect a USB connection through the USB1 slot.
Table 1 LED Descriptions (continued)
LED COLOR STATUS DESCRIPTION