Note
• If your phone system dealer does not allow you these settings, you cannot change them even though
the unit shows the setting menu. Contact your phone system dealer for further information.
• If you select "DHCP"/"Enable IPv6 DHCP" for the connection mode, all the settings concerning static
connection will be ignored, even if they have been specified.
• If you enable "DHCP"/"Enable IPv6 DHCP" for the connection mode and "Auto DNS"/"IPv6 Auto
DNS" for DNS, the DNS server settings (DNS1 and DNS2) will be ignored, even if they have been
specified.
1.1.3 Overview of Programming
There are 3 types of programming, as shown in the table below:
Programming
Type
Description References
Phone user
interface
programming
Configuring the unit’s settings directly from the unit.
® 1.1.4 Phone User Interface
Programming
® Section 3 Phone User
Interface Programming
Web user
interface
programming
Configuring the unit’s settings by accessing the Web
user interface from a PC connected to the same
network.
® 1.1.5 Web User Interface
Programming
® Section 4 Web User
Interface Programming
Configuration file
programming
Configuring the unit's settings by creating
configuration files and having the unit download the
files from a server on the Internet.
® Section 2 Provisioning
® Section 5 Configuration
File Programming
1.1.4 Phone User Interface Programming
You can change the settings directly from the unit.
For details about the operations, refer to the Operating Instructions on the Panasonic Web site (® see
Introduction).
For details about additional features available with direct commands, see Section 3 Phone User Interface
Programming.
26 Administrator Guide Document Version 2014-05
1.1.4 Phone User Interface Programming