Filter
Top Products
Value Range
• Y (Enable firmware updates)
• N (Disable firmware updates)
Default Value
Y
Web User Interface Reference Enable Firmware Update (Page 170)
FIRM_VERSION
Value Format String
Description Specifies the firmware version of the unit (e.g. nn.nnn [n=0-9]).
Note
• Changing this setting may require restarting the unit.
Value Range Not applicable.
Default Value Empty string
FIRM_FILE_PATH
Value Format String
Description Specifies the URL where the firmware file is stored.
Note
• This setting is available only when
"FIRM_UPGRADE_ENABLE" is set to "Y".
• Changing this setting may require restarting the unit.
Value Range Max. 1024 characters
Note
• The format must be RFC 1738 compliant, as follows:
"<scheme>://<user>:<password>@<host>:<port>/<url-path>".
– "<user>" must be less than 127 characters.
– "<password>" must be less than 127 characters.
– "<user>:<password>@" may be empty.
– ":<port>" can be omitted if you do not need to specify the
port number.
• If "{mac}" is included in this URL, it will be replaced with the
unit’s MAC address in lower-case.
• If "{MAC}" is included in this URL, it will be replaced with the
unit’s MAC address in upper-case.
• If "{MODEL}" is included in this URL, it will be replaced with the
unit’s model name.
• If "{fwver}" is included in this URL, it will be replaced with
"FIRM_VERSION" depending on the system. Note that this rule
differs from other parameters such as "SIP_USER_AGENT".
Default Value Empty string
228 Administrator Guide Document Version 2014-05
5.3.5 Firmware Update Settings