Filter
Top Products
Tone Timings
Description Specifies the pattern, in milliseconds, of dial tones using up to 10 whole
numbers (off 1, on 1, off 2, on 2…) separated by commas.
Note
• The unit will not play the tone for the duration of the first value,
play it for the duration of the second value, stop it for the
duration of the third value, play it again for the duration of the
fourth value, and so on. The whole sequence will then repeat.
For example, if the value for this setting is "100,100,100,0", the
unit will not play the tone for 100 ms, play it for 100 ms, stop it
for 100 ms, and then play it continuously.
• It is recommended that you set a value of 60 milliseconds or
more for the first value (off 1).
Value Range 1–60 characters
0–16000 (0: Infinite time)
Note
• Avoid setting 1–50 for any of the values.
Default Value 60,0
Configuration File Reference DIAL_TONE1_TIMING (Page 265)
4.6.6.2 Busy Tone
Tone Frequencies
Description Specifies the dual-tone frequencies, in hertz, of busy tones using 2
whole numbers separated by a comma.
Value Range 1–9 characters
0, 200–2000 (0: No tone)
Default Value 480,620
Configuration File Reference BUSY_TONE_FRQ (Page 266)
Tone Timings
Description Specifies the pattern, in milliseconds, of busy tones using up to 10
whole numbers (off 1, on 1, off 2, on 2…) separated by commas.
Note
• It is recommended that you set a value of 60 milliseconds or
more for the first value (off 1).
Value Range 1–60 characters
0–16000 (0: Infinite time)
Note
• Avoid setting 1–50 for any of the values.
148 Administrator Guide Document Version 2014-05
4.6.6 Tone Settings