Filter
Top Products
User Programming
User Manual 47
3.1.2 Programming Methods
Advancing to the next stage
When "USR-PGM NO? " is displayed, you can select one of the following:
• To go to program [000], press the NEXT button.
• To go to another program, enter the 3-digit program address.
Storing your data
Press STORE to store your data.
• The STORE indicator lights red and a confirmation tone sounds.
Making another selection within the same program address
• To go to the next selection, press NEXT.
• To go to the previous selection, press PREV.
• To make a specific selection, press SELECT and then enter the number.
Accessing another program address
a) While displaying the program address and title:
• To go to the next Larger program address:
Press the or MESSAGE button.
• To go to the next Smaller program address:
Press the or SECRET (INTERCOM) button.
b) While programming:
• To go to a specific program address:
Press END, then enter the program address.
Returning to the operation mode
1. Lift the handset while in programming mode.
2. When the Initial Message: USR-PGM NO? is displayed, press the PAUSE button.
(To display the Initial Message, press END.)
* Confirmation tone (one beep)
After pressing STORE, you will hear a beep. This informs you that storage has been
completed successfully.
* Confirmation tone (two beeps)
This informs you that the parameter has already been stored.
* Alarm tone (three beeps)
If you hear this alarm, your entry is not valid.