Filter
Top Products
Station Programming
30 User Manual
2.1 Station Programming Instructions
2.1.1 Station Programming Instructions
Station Programming allows you, the proprietary telephone (PT) users, to program certain
features from your telephone individually. To program, you need to switch your telephone to
the Station Programming mode. During programming mode, your telephone is in the busy
condition to both inside and outside callers. If you want to make a normal call handling
operation, you must finish the programming mode.
Programming Mode Display
When you enter into the Station Programming mode, the display shows the following message
as the initial programming mode;
We recommend a PT with display for Station Programming to avoid mis-operation.
The display also gives you helpful or stored data information related to your programming
steps. In this section, we note the display example in the programming steps, if required. You
can also refer to the "Display Examples" in the Appendix (Section 6).
Entering Station Programming mode
PT-PGM Mode
PT
Press PAUSE.
Dial 99.
9 9
<PT Display Example>
Be sure that the telephone is idle and on-hook.
PT-PGM Mode
If there is no entry within one minute, the Station Programming mode
is canceled and normal call handling mode resumes automatically.
The STORE indicator lights.
If 99 is not dialed within 5 seconds after the PAUSE button is
pressed, the Station Programming mode is canceled.
Initial programming display
-
PAUSE