Filter
Top Products
Station Programming
User Manual 31
Exiting Station Programming mode
Confirming the assigned function data
— Be sure that you are in the Station Programming mode: Press [PAUSE] [9] [9].
— To exit the Station Programming mode: Press [PAUSE] or lift the handset.
— If you wish to change the data, follow the programming procedure explained in this section.
PT
Press PAUSE or lift the handset.
To exit the Station Programming mode, press PAUSE. You are in the call
handling mode.
When the display shows the initial programming mode;
or
PAUSE
PT
Press HOLD (END).
Enter the program access number.
program access number
Enter the program access number* as follows.
- 1:Preferred Line Assignment
-
Outgoing
- 2:Preferred Line Assignment
-
Incoming
- 3:Full One-Touch Dialing Assignment
- 4:Intercom Alert Assignment
- 5:Call Waiting Tone Type Assignment
- 6:Self-Extension Number Confirmation
- 7:Live Call Screening Mode Set
-81:Initial Display Selection
-01:Remote Station Look Control (
-
Operator / Manager only)
-02:Call Log Lock Control, Incoming (
-
Operator / Manager only)
-03:Live Call Screening Password Control (
-
Operator / Manager only)
- #:Station Programming Data Default Set
The display shows the programmed data.
<PT Display Example>
When you press [5], the display shows:
(
-
The Call Waiting tone is currently programmed to Tone 1.)
The display shows the initial programming mode.
C.W. Tone1
† : Available when the Advanced Hybrid System is connected to a Proprietary Telephone capable Panasonic Voice Processing
System (one that supports DPT Integration; e.g., KX-TVS50)
* A programming access number is required to program/confirm the function data by Station Programming.
†
†
HOLD