Filter
Top Products
Chapter 4: Using the web interface
60 Introduction
Accessing and navigating the web interface
Accessing the web interface
To access the web interface, do as follows:
1. Connect your computer to the terminal.
2. Start up the terminal.
For further information, see Getting started on page 19.
3. Open your browser and enter the IP address of the terminal.
The standard IP address is 192.168.0.1.
Note
If the IP address is changed and you do not have the new address,
you can temporarily set the IP address to the default value by
pressing the Reset button next to the SIM slot in the connector panel
of the terminal. You can then access the web interface and change
the IP address.
Note that if you do not change the IP address, the default IP address
will only be valid until the terminal is powered off. Then the terminal
returns to the IP address from before the Reset button was pressed.
For further information on the Reset button, see Reset button on
page 180.
BGAN-X_UM.book Page 60 Wednesday, April 30, 2008 12:48 PM