Filter
Top Products
Chapter 5: Troubleshooting
Reset button 181
55555
Troubleshooting
Function of the Reset button
The Reset button on the terminal has the following functions:
Action Function
With the terminal
running, press the
Reset button
normally.
The terminal IP address and IP netmask are
temporarily set to the default value (default IP
address: 192.168.0.1).
With this function, even if the IP address has been
changed and you do not remember the new IP
address, you can still access the web interface and
see your current configuration. The default value is
not saved in the configuration, but is only valid until
next reboot.
With the terminal
running, press
and hold the Reset
button for 30
seconds, until the
Power indicator
on the terminal is
flashing orange.
The terminal restores factory settings and reboots the
system.
While the terminal
is booting, press
and hold the Reset
button.
For service use only!
The bootloader initiates software upload.
Refer to the installation manual for details.
BGAN-X_UM.book Page 181 Wednesday, April 30, 2008 12:48 PM