Filter
Top Products
Chapter 4: Using the web interface
88 Setting up the interfaces
Setting up the LAN interface
Do as follows:
1. From the left navigation pane, select SETTINGS > LAN.
2. At DHCP status, select Enabled (recommended), or Disabled.
•If you select Enabled, the terminal assigns dynamic IP addresses to
devices connected to the terminal.
•If you select Disabled, you need to set up a static IP address in the
connected device.
3. Type in the Local IP address and the Netmask.
The Local IP address is the IP address used for accessing the web
interface.
4. Click Apply.
BGAN-X_UM.book Page 88 Wednesday, April 30, 2008 12:48 PM