Filter
Top Products
Chapter 2: Getting started
Starting up the terminal 23
22222
Getting started
you can always switch the terminal back on with the remote switch. The
standby current when the remote switch is off is max. 2 mA. For further
information on the remote on/off function, refer to the installation manual for
the TracPhone systems.
Power up completed
When the terminal is switched on, the Power indicator in the LED panel of the
terminal lights green.
You can now access the terminal settings, but the terminal is not ready for
making calls or running data sessions until the system is registered on the
BGAN network. This normally requires that you enter a SIM PIN. For further
information, see Entering the SIM PIN for the terminal on page 26 and
Registering on the BGAN network on page 30.
To switch off the terminal tip the Power switch back. It takes 5 to 10 seconds to
power down the terminal. Alternatively use the ignition or remote on/off
function described above.
BGAN-X_UM.book Page 23 Wednesday, April 30, 2008 12:48 PM