Filter
Top Products
Softkey/Programmable Key/Feature Key/Expansion Module Key Parameters
41-001160-03, Rev 00, Release 2.4 A-203
• flash - Indicates programmable key is set to generate a flash event
when it is pressed. The IP phone generates flash events only when
a call is connected and there is an active RTP stream (for example,
when the call is not on hold).
• sprecode - Indicates programmable key is configured to
automatically activate specific services offered by the server. For
example, if the sprecode value of *82 is configured, then by
pressing the softkey, *82 automatically activates a service provided
by the server.
• park - Indicates programmable key is configured to park incoming
calls when pressed.
• pickup - Indicates programmable key is configured to pick up
parked calls when pressed.
• lcr - Indicates programmable key is configured for “last call return”
when pressed.
• call forward - Indicates the programmable key is configured for
accessing the Call Forward features on the phone. A Call
Forwarding Mode must be enabled to use this softkey. “Account”
mode is the default.
• blf/xfer - Indicates the programmable key is configured to transfer
calls AND configured for BLF on a single key.
• speeddial/xfer - Indicates the programmable key is configured to
transfer calls AND configured for speeddialing to a specific number.
• speeddial/conf - Indicates the programmable key is configured to
be used as a speeddial key AND as a conference key.
• dir - Indicates programmable key is configured to access the
Directory List.
• callers - Indicates programmable key is configured to access the
Callers List.
• conf - Indicates programmable key is configured as a conference
key. Enter as “conf” in configuration files.
• xfer- Indicates programmable key is configured as a Transfer key
for transferring calls. Enter as “xfer” in configuration files.
• services - Indicates the programmable key is set to be used as the
Services key.
• phonelock - Indicates the programmable key is set to be used to
lock/unlock the phone.
• paging - Indicates the softkey is set for Group Paging on the phone.
Pressing this key automatically sends a Real Time Transport
Protocol (RTP) stream to pre-configured multicast address(es)
without involving SIP signaling.
• empty - Indicates programmable key is configured to force a blank
entry on the IP phone display for a specific programmable key.
Format Te xt
Default Value Not Applicable
Draft 1