Filter
Top Products
Operational, Basic, and Advanced Parameters
41-001160-03, Rev 00, Release 2.4 A-65
SIP Local Dial Plan Settings
Parameter –
sip dial plan
Local Dial Plan
(in Web UI)
Aastra Web UI Basic Settings->Preferences
Configuration Files aastra.cfg, <mac>.cfg
Description A dial plan describes the number and pattern of digits that a user dials to
reach a particular telephone number. The SIP local dial plan is as follows:
Symbol Description
0, 1, 2, 3, 4, 5, 6, 7, 8, 9 Digit symbol
X Match any digit symbol (wildcard)
*, #, . Other keypad symbol; # can terminate
a dial string
| Expression inclusive OR
+ 0 or more of the preceding digit symbol
or [] expression
[] Symbol inclusive OR
- Used only with [], represent a range of
acceptable symbols; For example, [2-8]
“,” (open/close quotes) In the configuration files, enter the sip dial
plan value using quotes.
.;. Used when a secondary dial tone is
required on the phone. (For example,
“9;xxxxxx”, when a user has to dial “9” to get
and outside line and needs a secondary dial
tone presented.
Note: You can configure prefix dialing by adding a prepend digit to the
dial string. For example, if you add a prepend map of
“[2-9]XXXXXXXXX,91”, the IP phone adds the digits “91” to any 10-digit
number beginning with any digit from 2 to 9 that is dialed out. Other
examples of prepend mappings are:
• 1X+#,9 (Prepends 9 to any digit string beginning with “1” and
terminating with “#”.)
• 6XXX,579 (Prepends “579” to any 4-digit string starting with “6”.)
• [4-6]XXXXXX,78 (Prepends “78” to any 7-digit string starting with “4”,
“5”, or “6”.
Format Alphanumeric characters
Default Value X+#|XX+*
Range Up to 512 alphanumeric characters.
Note: If a User enters a dial plan longer than 512 characters, or a parsing
error occurs, the phone uses the default dial plan of “x+#|xx+*”. If this is
the case, the Administrator cannot change the dial plan from the
configuration files. The dial plan must be changed from the Aastra Web
UI.
Example sip dial plan: "X+#|XXX+*"
Draft 1