Filter
Top Products
Administrator Level Options
41-001160-03, Rev 00, Releaes 2.4 3-73
Administrator Options
Action URI
The IP phones have a feature that allows an administrator to specify a uniform
resource identifier (URI) that triggers a GET when certain XML events occur. The
Action URI feature prevents the phones from hanging if the Action URIs should
fail. The phones also support transparent, non-blocking, XML post execute item
URIs.
The IP phone XML events that support this feature are defined in the following
table.
You can set these parameters using the configuration files or the Aastra Web UI.
Action URI Description
Startup Specifies the URI for which the phone executes a GET on
when a startup event occurs.
Successful Registration Specifies the URI for which the phone executes a GET on
when a successful registration event occurs.
Registration Event Specifies the URI for when registration events occur or when
there are registration state changes.
Note: This action URI is not called when the same event is
repeated (for example, a timeout occurs again when
registration is already in a timeout state.)
Incoming Call Specifies the URI for which the phone executes a GET on
when an incoming call event occurs.
Outgoing Call Specifies the URI for which the phone executes a GET on
when an outgoing call event occurs.
Offhook Specifies the URI for which the phone executes a GET on
when an offhook event occurs.
Onhook Specifies the URI for which the phone executes a GET on
when an onhook event occurs.
Disconnected Specifies the URI that the phone executes a GET on, when it
transitions from the incoming, outgoing, calling, or connected
state into the idle state.
XML SIP Notify Specifies the URI to be called when an empty XML SIP
NOTIFY is received by the phone.
Poll Specifies the URI to be called every "action uri poll interval"
seconds.
Poll Interval Specifies the interval, in seconds, between calls from the
phone to the "action uri poll".
Draft 1