Filter
Top Products
Operational Features
5-238 41-001160-03, Rev 00, Releaes 2.4
IP Phone Administrator Guide
Configuring a Park/Pickup Key Using Aastra Web UI
On the 6757i/6757i CT and 9480i/9480i CT, you configure a Park and/or Pickup
key at Operation->Softkeys and XML. You enter a key label, and value for a
specific line on the phone. The default state of the Park configuration is
"connected". The default state of the Pickup configuration is "idle, outgoing".
The 6757i CT and 9480i CT handsets use the park/pickup configuration enabled
at Operation->Handset Keys in the Aastra Web UI. If Park or Pickup are
enabled on more than one line on the base unit, the 6757i CT and 9480i CT
handset uses the first programmable configuration.
For example, if line 1 and line 6 are configured for park, the 6757i CT and 9480i
CT handset uses the configuration set for line 1 to park a call.
On the 6753i and 9143i, you configure a Park and/or Pickup key at
Operation->Programmable Keys, and then enter the appropriate value and line.
Park/Pickup Call Server Configuration Values
*Leave "value" fields blank to disable the park and pickup feature.
Use the following procedure to configure the Park/Pickup call feature using the
programmable configuration method and the Aastra Web UI.
Note: Applicable values depend on the server in your network (Asterisk,
BroadWorks, Sylantro, ININ PBX. See the table below for applicable
values.
Server Park Values* Pickup Values*
Aasterisk 70 70
Sylantro *98 *99
BroadWorks *68 *88
ININ PBX callpark pickup
Draft 1