Filter
Top Products
Creating an XML Application
F-48 41-001160-03, Rev 00, Release 2.4
IP Phone Administrator Guide
RTPRx
The RTPRx URI instructs the phone to receive a Unicast RTP stream or stop
receiving Unicast or Multicast RTP streams. The RTPRx formats to use with the
AastraIPPhoneExecute object in the URI are:
• RTPRx:i:p:v
• RTPRx:Stop
Where
i Specifies the IP Address from which the stream is coming.
p Specifies the UDP port on which to receive the RTP stream.
Ensure that this is a number greater than 3100.
v
(optional)
Indicates the optional volume setting that controls the volume of the stream
playout. The supplied value is an offset to the current volume setting. After the
initial volume level gets set and the stream starts, you can manually change
the volume level as required using this “v” option. If you do not specify the
optional volume parameter, the phone uses the current volume setting on the
phone as the default.
Stop Specifies to stop any active RTP stream from being received on channel one.
Example: This example receives a unicast RTP stream from 10.30.100.20 at UDP port
21000 with the voice settings at 3 levels more than the current offset.
<AastraIPPhoneExecute>
<ExecuteItem URI = ”RTPRx:10.30.100.20:21000:3”>
<AastraIPPhoneExecute>
Example:
This example receives a unicast RTP stream from 10.30.100.20 at UDP port 21000 with
the voice settings as used in the previous RTP stream.
<AastraIPPhoneExecute>
<ExecuteItem URI = ”RTPRx:10.30.100.20:21000”>
<AastraIPPhoneExecute>
Example:
This example stops an incoming active multicast/unicast RTP stream.
<AastraIPPhoneExecute>
<ExecuteItem URI=”RTPRx:Stop”>
<AastraIPPhoneExecute>
Draft 1