Filter
Top Products
Administrator Level Options
3-22 41-001160-03, Rev 00, Releaes 2.4
IP Phone Administrator Guide
Preferred Line Timeout
(seconds)
Note: This option can
be set by both Users
and Administrators.
preferred line timeout Specifies the time, in seconds, that the phone
switches back to the preferred line after a call
(incoming or outgoing) ends on the phone, or after a
duration of inactivity on an active line.
For more information on this feature, see “Preferred
Line and Preferred Line Timeout” on page 5-81.
Goodbye Key Cancels
Incoming Call
Note: This option can
be set by both Users
and Administrators.
goodbye key cancels
incoming call
Enable or disables the behavior of the Goodbye Key
on the IP phone.
For more information on this feature, see “Goodbye
Key Cancels Incoming Call” on page 5-85.
UPnP Mapping Lines
Note: This option can
be set by both Users
and Administrators.
upnp mapping lines Enables or disables the use of Universal Plug and
Play (UpnP) on a specific line on the IP phone.
For more information on this feature, see “UPnP
Mapping Lines (for remote phones)” on page 5-87.
Message Waiting
Indicator Line
Note: This option can
be set by both Users
and Administrators.
mwi led line Allows you to enable the Message Waiting Indicator
(MWI) on a single line or on all lines on the phone. For
example, if you set this parameter to 3, the LED
illuminates if a voice mail is pending on line 3. If you
set this parameter to 0, the LED illuminates if a voice
mail is pending on any line on the phone (lines 1
through 9).
For more information on this feature, see “Message
Waiting Indicator Line” on page 5-89.
DND Key Mode
Note: This option can
be set by both Users
and Administrators.
dnd key mode Allows you to configure the DND mode to use on the
phone (Account, Phone, Custom) when the DND key
is pressed. You can configure DND for all accounts or
a specific account.
For more information on this feature, see “DND Key
Mode” on page 5-91. Also see Chapter 5, the section,
“Do Not Disturb (DND)” on page 5-211.
Parameter in
Aastra Web UI
Parameter in
Configuration Files
Description
Draft 1