Filter
Top Products
Section 700 - Operation Chapter 4. User Maintenance
576-13-700 DBS 576 (USA), Revised 6/11/98 75
Note: Once in a data entry level, you must either enter an acceptable value or restore the previous
value before proceeding. For instance, if you change an entry to an unacceptable value and then press
FF1
to move to the PSD Assignment menu, you will not be able to proceed. You must first enter an
acceptable value.
Operation
To enter User Maintenance mode:
Note: Your extension’s Class of Service must be properly set to allow User Maintenance access.
Also, only one user may enter User Maintenance or System Programming at a time.
Set System Date/Time/Day
Description
The System allows you to change the date, time, and day of week. When setting the time, you can
specify 12 or 24 hour format.
Operation
To change the system date, time, and day of week:
Action Result
1. At a telephone with a COS that allows user login, press the
ON/OFF
key.
2. Press the
PROG
key.
3. Press the
*
key twice (
*
*
).
4. Press the
CONF
key.
81-
User MAINT
displays
Action Result
1. If not already in User Maintenance mode, enter User Main-
tenance mode. (See “To enter User Maintenance mode:” on
page 75.)
81-
User MAINT
displays
2. At the
81
level, enter
000
.
3. Press the
HOLD
key.
0 :YYMMDD
Date
displays
4. Enter the year (two characters), month (two characters), and
day (two characters).
Note:
To clear an entry or existing data, press the
FLASH
key.
5. Press the
HOLD
key.
1:HHMM
Time
displays