Filter
Top Products
Section 700 - Operation Chapter 3. System Features
576-13-700 DBS 576 (USA), Revised 6/11/98 49
Each MCO trunk group is assigned to an MCO tenant group for incoming calls and for outgoing calls.
By default, Trunk Group 1 is assigned to MCO Tenant Group 1, Trunk Group 2 is assigned to MCO
Tenant Group 2, etc. for both incoming and outgoing calls.
For outgoing calls, each tenant group has 5 auto-trunk selections available. By default the first auto-
trunk selection is seized by entering 9, the second by entering 81, etc.
The number of MCO tenant groups available depends on the number of ports in the system as follows:
• 96-port system: ....1 to 12 MCO tenant groups
• 192-port system: ...1 to 24 MCO tenant groups
• 288-port system: ...1 to 36 MCO tenant groups
• 384-port system: ...1 to 48 MCO tenant groups
• 480-port system: ...1 to 60 MCO tenant groups
• 576-port system: ...1 to 72 MCO tenant groups
Hardware Requirements
•N/A
Related Programming
• FF1-3: MCO Incoming/Outgoing
• FF5-2: MCO Outgoing Trunk Assignments
• FF5-3: MCO Incoming Trunk Assignments
• FF2: Trunk Tenant Group Assignments
• FF3: Extension Tenant Group Assignments
Considerations
• When you first assign a trunk to a Trunk Tenant Group from the initial setting of (0), the system
automatically assigns the trunks as a member of the same number MCO Trunk Group (FF5-2 and
FF5-3). For instance, if Trunk 10 is assigned as a member of Trunk Tenant Group 1, then Trunk
10 is automatically assigned as a member of MCO Outbound Trunk Group 1 and MCO Inbound
Trunk Group 1. These assignments can be manually changed if desired.
Memory Backup
Description
Data stored in the CPC card can be copied to another CPC card in the OP2 card slot for the first
cabinet. This is particularly useful when performed after completion of initial system setup (as a
recovery measure) or before major changes are made to system configuration. This backup CPC can
then be used to immediately restore system operation.
This feature is a maintenance feature to be performed by the System certified dealer only.
Hardware Requirements
• A second CPC card that matches the type installed must be used to copy the memory.
Related Programming
•N/A