Filter
Top Products
38 DBS 576 (USA), Revised 6/11/98 576-13-700
Chapter 3. System Features Section 700 - Operation
Table 6. System Mode Impact on TRS, Ringing, Attendant, and Built-in Voice Processing Unit
Manual Day/Night Mode
You can manually change the System mode to Day 1, Day 2, Night, Night 2, or Night 3 mode by
either entering the correct dial code or by pressing the appropriately programmed FF key.
When using manual mode, the System may be configured to either use MCO tenant Day/Night modes
or system-wide Day/Night mode.
Operation
To switch Day/Day 2/Night modes using Feature Access Codes:
SYSTEM
MODE
TRS RING ATTENDANT
BUILT-IN
VOICE
PROCESSING
UNIT
Day 1 Day TRS Mode Day 1 Ring Pattern Day 1 Attend. Group Day 1 Message
Day 2 Day TRS Mode
(Same for Day 1 and
Day 2)
Day 2 Ring Pattern Day 2 Attend. Group
Handling
Day 2 Message
Night Night TRS Mode
(Same for Night 1,
and 2)
Night Ring Pattern
(Same for Night 1,
and 2)
Night Attend. Group
(Same for Night 1,
and 2)
Night Message
Night 1 Night TRS Mode
(Same for Night 1,
and 2)
Night Ring Pattern
(Same for Night 1,
and 2)
Night Attend. Group
(Same for Night 1,
and 2)
Night 1 Message
Night 2 Night TRS Mode
(Same for Night 1,
and 2)
Night Ring Pattern
(Same for Night 1,
and 2)
Night Attend. Group
(Same for Night 1,
and 2)
Night 2 Message
Switch Mode Procedure Indication
Toggle Day and
Night Modes
1. Press the
ON/OFF
key. Intercom dial tone
ON/OFF
LED lights
2. Enter
760
.
3. Press the
ON/OFF
key
ON/OFF
LED goes off
If changing to Night mode,
Red
LED lights
If changing to Day mode,
Red
LED goes off
Day 2 Mode
1. Press the
ON/OFF
key. Intercom dial tone
ON/OFF
LED lights
2. Enter
761
for the
Day 2 Feature
code.
3. Press the
ON/OFF
key
ON/OFF
LED goes off
Red
LED goes off