Filter
Top Products
262 DBS 576 (USA), Revised 6/11/98 576-13-700
Chapter 7. SLT Features Section 700 - Operation
Related Programming
• F1-0-03: Extension COS (Hookflash Control on SLTs - Broker’s Hold or Conference)
• FF3: Extension COS
Considerations
• If Broker’s Hold is enabled, it is not possible to establish a conference call from an SLT position.
Call Park
You can use the Call Park function to transfer a call, even if you cannot locate the intended recipient
of the call.
CO, Extension, and Network calls may be parked.
There are two ways for an extension to park a call on the DBS 576. One way is to park the call at the
receiving extension and to retrieve the parked call at another extension by dialing the park answer
code plus the parking extension number. The other way is to park the call at another extension and dial
the park transfer answer code at the other extension to retrieve the call.
Operation
To park a call on this extension:
To retrieve a call parked at the originating extension from another extension:
To park a call at another extension:
Action Result
1. While on a call, press the hookswitch.. • Intercom dial tone
2. Enter the Call Park Hold access code (default
771)
3. If necessary, page the party that needs to retrieve the call.
Action Result
1. Lift the handset Intercom dial tone
2. Enter the Call Park Answer/Other Ext. access code (default
773)
.
3. Dial the number of the extension that parked the call. • Connected to parked call
Action Result
1. While on a call, press the hookswitch. • Intercom dial tone
2. Enter the Call Park Transfer access code (default
774)
3. Dial the extension number to receive the parked call.
4. If necessary, page the party that needs to retrieve the call.