Filter
Top Products
240 DBS 576 (USA), Revised 6/11/98 576-13-700
Chapter 6. DSLT Features Section 700 - Operation
* Indicates that the digits that follow are either a feature access code or an extension
number. (Not needed if your System is set for Intercom Level.) See Note below.
** Indicates that the digits that follow are for an outside number and the System should
seize the next available trunk when dialing. (Not needed if your System is set for CO
Level.) See Note below.
Note:
The System has two levels - CO Level and Intercom Level. If set at CO Level (default),
you must enter the code for Intercom Level when programming a feature access code or
extension number for speed dialing. If the System is set at Intercom Level, you must enter the
MCO Code when programming an outside number for speed dialing.
System Speed Dial
You can store frequently called numbers using the SSD feature. Either 80 or 800 SSD numbers can be
programmed, depending on how the System is configured. In an 80 SSD-number system, the SSD
numbers are stored in bins 00-79. In 800 SSD-number systems, the SSD numbers are stored in bins
000-799.
Operation
To assign SSD numbers:
To dial an SSD number by entering the speed dial bin number:
Action Result
1. Lift the handset or press the
ON/OFF
key. Intercom dial tone
2. Enter the Speed Dial Set/Clear code (default =
710
).
3. Enter the SSD bin number (
00
-
79
or
000
-
799
).
4. Dial the phone number.
5. Press the
HOLD
key.
6. Replace the handset or press the
ON/OFF
key.
Action Result
1. Lift the handset or press the
ON/OFF
key. Intercom dial tone
2. If necessary, access an outside line. Outside dial tone
3. Press the
AUTO
key.
OR...
Enter the Speed Dial Originate code (default =
80
).
4. Enter the SSD bin number (
00
-
79
or
000
-
799
).
5. Complete call and replace the handset or press the
ON/OFF
key.