Filter
Top Products
100 DBS 576 (USA), Revised 6/11/98 576-13-700
Chapter 4. User Maintenance Section 700 - Operation
(For a description of Automatic Day/Night System Mode, see “Automatic Day/Night Mode” on page
39.)
You can specify exception days which allow for a range of days for the System to operate in the Night
mode. This is intended for extended holidays for business shut down periods that last for multiple
days. You can specify up to 6 exception day periods.
Operation
To set the Exception Day Modes:
Action Result
1. If not already in User Maintenance mode, enter User Main-
tenance mode. (See “To enter User Maintenance mode:” on
page 75.)
81-
User MAINT
displays
2. At the
81
level, enter
07
.
3. Press the
HOLD
key.
8107-
System Mode
displays
4. Enter
2
.
5. Press the
HOLD
key.
2-
Mode Except Day
displays
6. Press the
HOLD
key.
200 :MMDD
PTN 1 Start Day
displays
7. Enter
the start date by month (two characters) and day (two
characters) for Exception Period 1.
Note:
To clear an entry or existing data, press the
FLASH
key.
8. Press the
HOLD
key.
201 :MMDD
PTN 1 Stop Day
displays
9. Enter the stop date by month (two characters) and day (two
characters) for Exception Period 1.
Note:
To clear an entry or existing data, press the
FLASH
key.
10. Press the
HOLD
key. Next Exception Day mode displays
11. To set additional Exception Day modes, press the volume
up or down key or press the
HOLD
key to move to the
desired mode.
Desired Exception Day mode displays
12. Repeat steps 7-11 until all Exception Day modes are set.
(Up to 6 exception periods may be specified.)
Note
: The entry positions are listed in Table 11 on page
101.