Filter
Top Products
Call Log 91
To manually log an external call:
1.
Press
OR
Press a memory key programmed with this feature code.
(See the Feature programming section in this chapter.)
Use Autobumping
Since your log has a set number of entries that it can hold,
Autobumping is a feature that lets you tell
what to do
when your log becomes full. When Autobumping is on, a new log
entry causes the first entry to be deleted. If Autobumping is off,
your
system will not log new calls when your log is full.
1.
To turn Autobumping on, press
q q
.
OR
To turn Autobumping off, press [Feature]
q q
.
Enter Call Log
q q
You can enter your Call Log to view stored information. The Log
may display special characters. These are described in detail in
the description of Displays, later in this section. To view your log:
1. Press [Feature]
q q
.
2.
The display shows the number of previously read items (Old)
and the number of new, unread items (New) in the log.
3.
To view old items, press or
q
.
OR
To view new items, press
or
q
.
OR
To return to the item being viewed when you last exited the
log, press RESUME or
q
.
PO84262701
DR5.1 Owner’s Handbook