Filter
Top Products
48 Capabilities
When DND on Busy is turned on for the set, internal and private
network callers hear a busy tone instead of ringing when you are
on the telephone. External callers are transferred to the prime set
used in your system.
Press to toggle the setting on (Y) or off (N).
Programming hints
If you use DND on Busy, the line indicator for an external
incoming call still flashes, but your telephone does not ring.
Forward on busy takes priority over DND on busy.
Allow redirect
Allow redirect enables you to identify whether a telephone is
allowed access to the Line Redirection feature. Use the
display button to select the setting: Y (Yes) or N (No).
See the explanation of Line Redirection in the Telephone
.
features chapter for more information on redirecting lines.
Programming hints
The Allow redirect setting has no effect if Disconnect Supervision
is unavailable or was not enabled by your Customer Service
representative. See the System features section of the
Telephone features chapter for more information on Disconnect
Supervision.
Redirect ring
The Redirect ring setting causes a telephone to ring briefly (a
200 millisecond burst) when a call is redirected on one of its
lines. Each telephone with a ringing appearance of that line also
rings briefly for the redirected call if the Redirect ring setting for
them is
(the default). Use the display button to select
the setting: Y (Yes) or N (No).
A user enters the Line Redirection feature code to redirect calls.
See the explanation of Line Redirection in the Telephone
Features chapter for more information on redirecting lines.
Owner’s Handbook
PO84282701