Filter
Top Products
ND-71762 (E) CHAPTER 6
Page 73
Issue 2
BASIC DATA ASSIGNMENT
Assign trunk(s) to desired LENs using the ATRK command. In this instance, the MBTK command is not re-
quired for the signaling trunk.
Note: See 2.1 “Port Allocation and Related Command”.
Assign the associated PC on an RT (for speech path) number basis. In the case of the example illustrated in
Figure 6-1, appropriate data is as follows.
Assign the location of the CCH using the ACSC command. The following is sample data assignment. In this
sample, Node A is equipped with three DTI cards. Note that if the system employs one CCIS link, enter the
same data in CSCG130 and CSCG131.
Note 1: In the case of actual data entry, enter corresponding LEN numbers instead of letters such as “AAAAA”.
Note 2: Refer to 2.1 “Port Allocation and Related Command”.
STEP 5: Assignment of Trunk Data
COMMAND NAME
ATRK & MBTK
STEP 6: Assignment of DPC
COMMAND NAME
ADPC
RT PC
11 20
12 30
STEP 7: Assignment of Common Channel Signaling Controller (CSC)
COMMAND NAME
ACSC
CSCG MG U G CICG CSCG MG U G CICG
130
(Basic/
Primary Route)
AA A AA 0 CCH 0
131
(Alternate
Route)
CCCCC0
BBBBB1 CCCCC1
BBBBB2 CCCCC2
BBBBB3 CCCCC3 CCH 2
BBBBB4 CCH 1 CCCCC4
BBBBB5 CCCCC5
BBBBB6 CCCCC6
BBBBB7 CCCCC7