Filter
Top Products
ND-71762 (E) CHAPTER 6
Page 71
Issue 2
BASIC DATA ASSIGNMENT
Note 3:
When either of the two parties that are eventually connected (after a call transfer) is ATTCON, Link Re-
connection cannot be provided. (At this point, even if the ATTCON transfers the call to a station in the
same node and Station-to-Station connection is established, this function is not available.) In addition, this
function is not provided when either of the two parties that are eventually connected has a held party.
Note 4: In case a call is connected to the announcement trunks used for Delay Announcement-UCD service and
ACD Delay Announcement service, Link Reconnection function is not provided. (At this time, if the call is
eventually connected to UCD station/ACD agent position after the UCD station/ACD agent position be-
comes idle state, this function is provided.)
2) Index 187:Assign 00 Hex always.
Assign the following three routes for this feature:
• Speech Path Route (Traffic Route)
• Signaling Route
• Dummy Route (Flag Route).
STEP 2: Route Data Assignment
COMMAND NAME
ARTD
Station A
Station D
ATTCON C
Station B
Station A made a call to Station B
Station B transferred the call to Attendant Console C
Node A
Node B
Transfer to Station D
In the following case, Link Reconnection is not provided:
Example 3:
1. A call between Station A and Station B is established.
2. Station B transfers the call to ATTCON C.
3. After connecting to ATTCON C, Station B is released.
4. At this time, Link between Station A and ATTCON C is not reestablished.
5. ATTCON C transfers the call to Station D.
6. After connecting to Station D, ATTCON C is released.
7. Link Reconnection (between Station A and D) is not provided.
07/31/02