Filter
Top Products
3-13
Cisco Unified IP Phone 6921, 6941, and 6961 Administration Guide for Cisco Unified Communications Manager 7.1 (SCCP)
OL-19025-01
Chapter 3 Setting Up the Cisco Unified IP Phone
Configuring Startup Network Settings
2. The screen displays the Cisco Systems, Inc., logo screen.
3. These messages appear as the phone starts up.
–
Configuring IP message
–
Registering
4. The home screen displays:
–
Current date and time
–
Primary directory number
–
Additional directory numbers and speed dial numbers, if configured (Only on Cisco Unified IP
Phone 6961)
–
Softkeys
If the phone successfully passes through these stages, it
has started up properly. If the phone does not
start up properly, see the “Resolving Startup Problems” section on page 9-1.
Configuring Startup Network Settings
If you are not using DHCP in your network, you must configure these network settings on the
Cisco Unified IP Phone after installing the phone on the network:
• IP address
• IP subnet information
• TFTP server IP address
• You also may configure the domain name and the DNS server settings, if necessary.
Collect this information and se
e the instructions in Chapter 4, “Configuring Settings on the Cisco
Unified IP Phone.”
Ta ble 3-2 LED Diagnostic Status
Hardware Test MWI Hold Mute Speaker
Power is Ready On On On On
Flash is Accessible — On On On
RAM Test Successful — — On On
Ethernet Test Successful — — — On