Filter
Top Products
3-12
Cisco Unified IP Phone 6921, 6941, and 6961 Administration Guide for Cisco Unified Communications Manager 7.1 (SCCP)
OL-19025-01
Chapter 3 Setting Up the Cisco Unified IP Phone
Mounting the Phone to the Wall
Lower Viewing Angle
Mounting the Phone to the Wall
You can mount the Cisco Unified IP Phone on the wall by using special brackets available in a
Cisco Unified IP Phone wall mount kit. For information on installing the wall mount kit, see
Appendix E, “Installing the Wall Mount Kit for the Cisco Unified IP Phone 6921, 6941, and 6961” or
Appendix F, “Cisco Unified IP Phone Non-Lockable Wall Mount.”
Note Wall mount kits are ordered separately from the phone.
Verifying the Phone Startup Process
After the Cisco Unified IP Phone has power connected to it, the phone begins its startup diagnostic
process by cycling through the following steps.
1. The following LED buttons flash on and off during the various stages of bootup as the phone checks
its hardware. See Table 3-2 for a list of the hardware test and the LED diagno
stic status.
195160