Filter
Top Products
8-5
Cisco Unified IP Phone 6921, 6941, and 6961 Administration Guide for Cisco Unified Communications Manager 7.1 (SCCP)
OL-19025-01
Chapter 8 Monitoring the Cisco Unified IP Phone Remotely
Network Setup
TFTP Server 1 Primary Trivial File Transfer Protocol (TFTP) server used by the phone.
TFTP Server 2 Backup Trivial File Transfer Protocol (TFTP) server used by the phone.
Default Router 1–5 Default router used by the phone (Default Router 1) and optional backup routers (Default
Rou
ter 2–5).
DNS Server 1–5 Primary Domain Name System (DNS) server (D
NS Server 1) and optional backup DNS
servers (DNS Server 2–5) used by the phone.
Operational VLAN ID Auxiliary Virtual Local Area Network (VLAN) configured on a Cisco Catalyst switch in
which
the phone is a member.
Admin. VLAN ID Auxiliary VLAN in which the phone is a member.
Unified CM 1–5 - Host names or IP addresses, in pri
oritized order, of the Cisco Unified Communications
Manager servers with which the phone can register. An item can also show the IP address
of an SRST router that is capable of providing limited Cisco Unified Communications
Manager fu
nctionality, if such a router is available.
For an available server, an item wi
ll show the Cisco Unified Communications Manager
server IP address and one of the following states:
• Active—Cisco Unified Communications Manager server from which the phone is
currently receiving call-processing services.
• Standby—Cisco Unified Communications Manager server to which the phone
switches if the current server becomes unavailable.
• Blank—No current connection to this Cisco Unified Communications Manager server.
An item may also include the Survivable Remote Site Telephony (SRST) designation,
which
identifies an SRST router capable of providing Cisco Unified Communications
Manager fu
nctionality with a limited feature set. This router assumes control of call
processing if all other Cisco Unified Communications Manager servers become
unreac
hable. The SRST Cisco Unified Communications Manager always appears last in
the
list of servers, even if it is active. You configure the SRST router address in the Device
Pool section in Cisco Unified Communications Manager Configuration window.
Information URL URL of the help text that appears on the phone.
Directories URL URL of the server from which the phone obtains directory information.
Messages URL URL of the server from which the phone obtains message services.
Services URL URL of the server from which the phone obtains Cisco Unified IP Phone services.
DHCP Enabled Indicates whether DHCP is being used by the phone.
DHCP Address Released Indicates the setting of the DHCP Address Released option on the phone’s Network
Con
figuration menu.
Alternate TFTP Indicates whether the phone is using an alternative TFTP server.
Forwarding Delay Indicates whether the internal switch begins forwarding packets between the PC port and
sw
itched port on your phone when your phone becomes active. When forwarding delay is
set to disabled, the internal switch begins forwarding packets immediately. When
forwarding delay is set to enabled, the internal switch waits eight seconds before
forwarding packets between the PC port and the SW port. You should set forwarding delay
to enabled when you connect both ports to switches for redundant uplinks or when you
daisy-chain phones together.
Table 8-2 Network Configuration Area Items (continued)
Item Description