5-23
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator’s Guide (SCCP)
Ol-3141-01
Chapter 5 Parameters and Defaults
Optional Feature Parameters
• CallWaitTone = "1,30959,0,2392,0, 0, 1600, 4000,11200" (approximately -10 dBm)
• ConfirmTone = "1,30959,0,2392,0, 0, 480, 480,1920" (approximately -10 dBm)
Specific Call-Progress Tone Parameter Information
Brief descriptions, and lists of default values and the voice configuration menu code for each Cisco ATA
tone parameter, appear in the following sections:
• DialTone, page 5-23
• BusyTone, page 5-24
• ReorderTone, page 5-24
• RingbackTone, page 5-25
• CallWaitTone, page 5-25
• ConfirmTone, page 5-26
DialTone
Description
The Cisco ATA plays the dial tone when it is ready to accept the first digit of a remote address to make
an outgoing call.
This parameter is for specifying the inside dial tone in SCCP. The outside dial tone in SCCP is fixed at
450Hz+540Hz@-6dBm. The inside dial tone is the tone that the telephone plays when a phone inside
the PBX goes off-hook. The outside dial tone is the tone that the telephone plays when a phone inside
the PBX is connected to the PSTN.
Default values for the nine-integer array
• ntone—2
• freq0—31538
• freq1—30831
• level0—1380
• level1—1740
• steady—1
• on-time—0
• off-time—0
• total time to play tone—1000
Voice Configuration Menu Access Code
920