Filter
Top Products
5-17
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator’s Guide (SCCP)
Ol-3141-01
Chapter 5 Parameters and Defaults
Operating Parameters
Voice Configuration Menu Access Code
931
Related Parameters
• TftpURL, page 5-4
• CA0orCM0 and CA1orCM1, page 5-9
NumTxFrames
Description
Not used for SCCP. For information about RTP packet size configuration, which is controlled by the
Cisco CallManager, refer to your Cisco CallManager documentation.
UDPTOS
Description
Use this parameter to specify the default IP precedence (ToS bit) of UDP packets. Set the lower eight
bits only, as follows:
• Bits 0-1: Unused
• Bit 2: Reliability bit—1=request high reliability
• Bit 3: Throughput bit—1=request high throughput
• Bit 4: Delay bit—1=request low delay
• Bits 5-7: Specify datagram precedence. Values range from 0 (normal precedence) to 7 (network
control).
Value Type
Bitmap
Default
0xB8
Voice Configuration Menu Access Code
255
OpFlags
Description
Use this parameter to enable/disable various operational features.
See Table 5-3 for bit definitions of this parameter.
Value Type
Bitmap