Filter
Top Products
3-6
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator’s Guide (SCCP)
OL-3141-01
Chapter 3 Configuring the Cisco ATA for SCCP
Steps Needed to Configure the Cisco ATA
Steps Needed to Configure the Cisco ATA
This section contains the following topics:
• Basic Configuration Steps in a Cisco CallManager TFTP Server Environment, page 3-6
• Basic Configuration Steps in a Non-TFTP Server Environment, page 3-7
Basic Configuration Steps in a Cisco CallManager TFTP Server Environment
Table 3-3 shows the basic steps for configuring the Cisco ATA and making it operational in a typical
SCCP environment, which includes a Cisco CallManager TFTP server.
Table 3-3 Basic Steps to Configure the Cisco ATA in a Typical Cisco CallManager Environment
Action Reference
1. Download the desired Cisco ATA release software zip file from the
Cisco web site and store it on the Cisco CallManager TFTP server.
Setting Up the TFTP Server with Cisco ATA
Software, page 3-8
2. Create a default configuration file that can be used by many
Cisco ATAs in your Cisco CallManager environment.
Note You can skip this step if the Cisco ATA default parameters do not
require re-configuration in your network environment.
Creating a Cisco ATA Default Configuration File,
page 3-10
3. Configure the method with which the Cisco ATA will locate the
Cisco CallManager TFTP server at boot up time.
Configuring the Cisco ATA to Obtain its
Configuration File from the TFTP Server, page
3-15
4. Add the Cisco ATA to the Cisco CallManager. Chapter 4, “Adding the Cisco ATA to the
Cisco CallManager”
5. Power up the Cisco ATA.
6. Optionally, create a configuration file for a specific Cisco ATA. Creating a Configuration File for a Specific
Cisco ATA, page 3-12
7. If you make configuration changes to the Cisco ATA, you must reset
the Cisco ATA by using the Cisco CallManager administration web
pages.
Resetting the Cisco ATA Using
Cisco CallManager, page 3-23