Filter
Top Products
3-18
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator’s Guide (SCCP)
OL-3141-01
Chapter 3 Configuring the Cisco ATA for SCCP
Voice Configuration Menu
• DNS1IP
• DNS2IP
• Domain
This completes the parameter settings you need to configure in order for the Cisco ATA to contact the
TFTP server (without using DHCP) that will contain the configuration file for the Cisco ATA.
Voice Configuration Menu
The main reasons to use the voice configuration menu are to establish IP connectivity for the Cisco ATA
if a DHCP server is not being used in your network environment, and to reset the Cisco ATA to its factory
values if necessary. You can also use the voice configuration menu if you need to configure a small
number of parameters or if the web interface and TFTP configuration are not available.
Note Do not use the voice configuration menu to attempt to change any values that you configured by means
of the TFTP configuration file method. Whenever the Cisco ATA resets, it downloads its
ata<macaddress> configuration file or atadefault.cfg default configuration file from the TFTP server,
and the values in either of these files will overwrite the values of any corresponding parameters
configured with the voice configuration menu.
See Chapter 5, “Parameters and Defaults,” for a complete list of parameters and their definitions. Also
see Table 3-5 on page 3-8 for an alphabetical listing of configurable features and references to their
corresponding parameters.
This section contains the following topics:
• Using the Voice Configuration Menu, page 3-18
• Entering Alphanumeric Values, page 3-20
• Resetting the Cisco ATA to Factory Default Values, page 3-20
Using the Voice Configuration Menu
To manually configure the Cisco ATA by using the voice configuration menu and the telephone keypad,
perform the following steps:
Procedure
Step 1 Connect an analog touch-tone phone to the port labeled Phone 1 on the back of the Cisco ATA.
Step 2 Lift the handset and press the function button located on the top of the Cisco ATA. You should receive
the initial voice configuration menu voice prompt.
Step 3 Using the telephone keypad, enter the voice menu code for the parameter that you want to configure or
the command that you want to execute, then press #. For a list of voice menu codes, see Appendix B,
“Voice Menu Codes.”
Table 3-6 lists the menu options that you need to configure basic IP connectivity for the Cisco ATA, after
which you can use the Cisco ATA web configuration page to configure additional parameters.