Filter
Top Products
B-2
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator’s Guide (SCCP)
OL-3141-01
Appendix B Voice Menu Codes
Table B-2 lists configuration codes. For additional information about these parameters, see “Chapter 5,
“Parameters and Defaults.”
Table B-2 Cisco ATA Voice Menu Codes—Configuration Parameters
Option
Voice Menu
Code Description
Audio mode 312 Allows finer control of the audio component to suit
certain user applications
Caller ID method 316 Specifies the signal format when generating the
Caller ID format to use
Connection mode 311 Controls the connection mode of the call signaling
protocol
Dynamic Host Configuration
Protocol (DHCP)
20 Controls whether the Cisco ATA can automatically
obtain configuration parameters from a server over
the network
DNS 1 IP 916 IP address of the primary DNS server
DNS 2 IP 917 IP address of the secondary DNS server
Encrypt key 320 Encrypts the configuration file on the TFTP server
Num Tx frames 35 Number of frames transmitted per packet
Static IP address 1 IP address of the Cisco ATA
LBR codec 300 Low-bit-rate codec selection
Media port 202 Specifies which base port the Cisco ATA uses to
receive RTP media streams
Static network route address 2 Network router address
NPrintf address 81 IP address of a host to which all Cisco ATA debug
messages are sent
Set password 7387277 Configuration interface password
Signal timers 318 Timeout values controlling the starting or stopping
of a signaling event
MGCP protocol 38 Selects the signaling protocol
Static subnet mask 10 Specifies the subnet mask for the Cisco ATA
TFTP URL 905 When TFTP configuration is used, IP address of
the TFTP server
UDP TOS bits 255 Determines the precedence and delay of UDP IP
packets
Use TFTP 305 Enables TFTP as configuration method