Filter
Top Products
x
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator’s Guide (SCCP)
OL-3141-01
Preface
Conventions
Conventions
This document uses the following conventions:
• Alternative keywords are grouped in braces and separated by vertical bars (for example, {x | y | z}).
• Arguments for which you supply values are in italic font.
• Commands and keywords are in boldface font.
• Elements in square brackets ([ ]) are optional.
• Information you must enter is in boldface screen font.
• Optional alternative keywords are grouped in brackets and separated by vertical bars (for example,
[x | y | z]).
• Terminal sessions and information the system displays are in screen font.
Note Means reader take note. Notes contain helpful suggestions or references to material not covered in the
publication.
Timesaver Means the described action saves time. You can save time by performing the action described in the
paragraph.
Chapter 4, “Adding the Cisco ATA to the Cisco CallManager” Provides information about adding the Cisco ATA to the
Cisco CallManager environment.
Chapter 5, “Parameters and Defaults” Provides information on the parameters and defaults that you
can use to configure the Cisco ATA.
Chapter 6, “Configuring and Debugging Fax Services” Provides instructions for configuring both ports of the
Cisco ATA to support fax transmission.
Chapter 7, “Upgrading the Cisco ATA Signaling Image.” Provides instructions for remotely upgrading Cisco ATA
software.
Chapter 8, “Troubleshooting” Provides basic testing and troubleshooting procedures for the
Cisco ATA.
Appendix A, “How to Use Pre-call and Mid-call Services” Provides end-user procedures on how to use pre-call services
and mid-call services that the Cisco ATA supports.
Appendix B, “Voice Menu Codes” Provides a quick-reference list of the voice configuration
menu options for the Cisco ATA.
Appendix C, “Cisco ATA Specifications” Provides physical specifications for the Cisco ATA.
Appendix D, “SCCP Call Flows” Provides Cisco ATA call flows for SCCP scenarios.
Appendix E, “Performing a Cross-Protocol Upgrade” Provides instructions on changing from SCCP to a SIP,
MGCP or H.323 signaling image.
Glossary Provides definitons of commonly used terms.
Index Provides reference information.
Table 1 Cisco ATA 186 and Cisco ATA 188 Analog Telephone Administrator’s Guide (SCCP) Organization (continued)
Chapter Description