Filter
Top Products
4-22
Cisco Unified IP Phone 7970G/7971G-GE Administration Guide for Cisco Unified Communications Manager 7.0
OL-15299-01
Chapter 4 Configuring Settings on the Cisco Unified IP Phone
Device Configuration Menu
Power Save Configuration Menu
The Power Save Configuration menu displays the settings that control when the LCD screen on a phone
turns off to conserve power. Table 4-14 describes the options on this menu.
For detailed information about configuring these settings, see the “Automatically Disabling the Cisco
Unified IP Phone Touchscreen” section on page 6-7.
Enterprise Advertise
G.722 Codec
Enables/disables Cisco Unified IP Phones to
advertise the G.722 codec to Cisco Unified
Communications Manager. If enabled (default),
and if each endpoint in the attempted call supports
G.722 in its capabilities set, Cisco Unified
Communications Manager will choose G.722
for the call.
Note When a phone is registered with a Cisco
Unified Communications Manager that
does not support this setting, the default
is “Disabled.”
From Cisco Unified Communications Manager
Administration and choose System >
Enterprise Parameters.
Device Advertise G.722
Codec
Allows you to override the Enterprise Advertise
G.722 Codec on a per-phone basis.
The default is “Use System Default,” which
means the value configured for the Enterprise
Advertise G.722 Codec parameter gets used.
From Cisco Unified Communications Manager
Administration and choose Device > Phone.
Table 4-13 Media Configuration Menu Options (continued)
Option Description To Change
Table 4-14 Power Save Configuration Menu Options
Option Description To Change
Display On Time Time each day that the LCD screen turns on
automatically (except on the days specified in
the Days Display Not Active field).
From Cisco Unified Communications Manager
Administration, choose Device > Phone >
Phone Configuration.
Display On Duration Length of time that the LCD screen remains on
after turning on at the time shown in the Display
On Time option.
From Cisco Unified Communications Manager
Administration, choose Device > Phone >
Phone Configuration.
Display Idle Timeout Length of time that the phone is idle before the
display turns off. Applies only when the display
was off as scheduled and was turned on by an
end-user (by pressing a button on the phone,
touching the touchscreen, or lifting the handset).
From Cisco Unified Communications Manager
Administration, choose Device > Phone >
Phone Configuration.
Days Display Not
Active
Days that the display does not turn on
automatically at the time specified in the
Display On Time option.
From Cisco Unified Communications Manager
Administration, choose Device > Phone >
Phone Configuration.
Display On When
Incoming Call
Indicates whether the LCD screen automatically
illuminates when a call is received.
From Cisco Unified Communications Manager
Administration, choose Device > Phone >
Phone Configuration.