Filter
Top Products
4-17
Cisco Unified IP Phone 7970G/7971G-GE Administration Guide for Cisco Unified Communications Manager 7.0
OL-15299-01
Chapter 4 Configuring Settings on the Cisco Unified IP Phone
Device Configuration Menu
NTP Configuration Menu (SIP Phones Only)
The NTP Configuration menu displays information about the NTP server and mode configuration used
by SIP phones. Table 4-11 describes the options on this menu.
UI Configuration Menu
The UI Configuration menu displays the status of various user interface features on the phone.
Table 4-12 describes the options on this menu.
Network Locale Version Version of the network locale loaded on the
phone.
Display only—Cannot configure.
NTP Configuration (SIP
phones only)
Provides access to the NTP Configuration Menu.
For more information, see the “NTP
Configuration Menu (SIP Phones Only)” section
on page 4-17
Display only—Cannot configure.
Table 4-10 Locale Configuration Menu Options (continued)
Option Description To Change
Table 4-11 NTP Configuration Menu Options
Option Description To Change
NTP Server 1 IP address of the primary NTP server. Display only—Cannot configure.
NTP Server 2 IP address of the secondary or backup NTP
server.
Display only—Cannot configure.
NTP Mode 1 Primary server mode. Supported modes are
Directed Broadcast and Unicast.
Display only—Cannot configure.
NTP Mode 2 Secondary server mode. Supported modes are
Directed Broadcast and Unicast.
Display only—Cannot configure.
Table 4-12 UI Configuration Menu Options
Option Description To Change
Auto Line Select Indicates whether the phone shifts the call focus
to incoming calls on all lines.
When this option is disabled, the phone only
shifts the call focus to incoming calls on the line
that is in use. When this option is enabled, the
phone shifts the call focus to the line with the
most recent incoming call.
Default: Disabled
From Cisco Unified Communications Manager
Administration, choose Device > Phone >
Phone Configuration.
BLF for Call Lists Indicates whether the Busy Lamp Field (BLF) is
enabled for call lists.
From Cisco Unified Communications Manager
Administration, choose System > Enterprise
Parameters.