Filter
Top Products
R5976214 VisuPlus Video Insertion Unit June 2003
3-20
3.3.2 Switching on
Switch on VISU
PLUS
by applying the power switch [9] on front! When multiple VISU
PLUS
are used,
the order in which the V
ISU
PLUS
are switched on is of no importance.
When the system is powered on, the
green LED: Power [5] on the front panel will lighten up. If it
does not lighten up, see section
8 Troubleshooting.
When the system is switched on, the
red LED: Status [4] on the front panel will light up for one
second. When the status LED stays lighted up, see section
8 Troubleshooting.
Within a Visu
Plus
– Eos setup the Visu
Plus
units need to be powered on even if no
video or RGB-signal is inserted at all due to the loop through of the graphic signals
of Eos.
3.3.3 Switching off
To switch off VISU
PLUS
just push the power switch [9] on the front of VISU
PLUS
to 0.